Pustelnik pisze:Mam taki sam i też jestem ciekawy jak go programowałeś. W niedzielę będę zakładał.
select neutral, check the kill switch is in the run position and turn the ignition on. display will illuminate.
touch and hold the white programing wire to earth until the digi flashes "P" (this may take up to 60 seconds)
remove and remake the white wire to earth, the display will change to 2
remove and remake the white wire to earth, the display will change to 3
repeat for the number of gears the bike has
teaching the gears
engage neutral and start the engine
select 1 st gear, the digi display will show a flashing 1, relase the clutch
increase the engine speed to 2000 rpm and hold, the 1 on the display will flash increasingly quickly and will change to a bar
when the bar appears in the display 1 st gear has been logged successfully and the display will change ta a flashing 2
change into neutral from 1 st gear, pause in neutral until 0 is display on the digi
select 2 gear, the display will show a flashing 2, relase the clutch
check the engine speed is still at 2000 rpm, the 2 will flash increasingly quickly until a bar displayed, 2 gear now been logged successfully, the digi display will show a flashing 3
repeat the point of above procedure for the remaining gears
when the bar appears in top gear the display will scroll and the digi has been successfully programmed